Today, the editor will give you an answer. It can increase work efficiency. The editor has also checked a lot of information before finding the answer. Let me explain it to you in detail below.

When the climbing frame electric hoist is working, many electric hoists generally work together. If one of them is slow, it will affect the working efficiency of the overall electric hoist. How to improve the overall climbing frame electric hoist becomes an important issue.

First of all, before installation preparation: read the design drawings in detail, install the lifting beam and group hoist according to the medium amount that the bracket needs to bear, and drill the bolts at the design position. The positions of the bolt holes in each layer need to be consistent, so that the bracket can move smoothly and vertically, and the error is not allowed to be higher than 10mm.

Equipment installation: Preserve bolt holes on each wall of the wall, and clean up the gravel in the holes to ensure that the bolts can be firmly combined with the wall. Then install the tension support and the pull rod, where the strength of the pull rod must reach about 20MPa. After fixing the I-beam frame, you can install the group hoist electric hoist. The group hoist motor in each position needs to be numbered. The number is consistent with the specific height number of the climb. The chain of the motor itself should be kept at 90° from the ground. °Angle. When the chain is installed, there must be no twisting, turning, etc., and the dirty oil on the chain should be cleaned, and a rain-shielding canvas should be installed for the motor.

It turns out that installing a climbing frame electric hoist reasonably can also improve work efficiency, so we must determine the location when installing it, and other reasons. When we don’t know it, we can talk to the engineer or come to the editor. Leave a message, I will answer you later.