Climbing frame
electric hoists are now used very frequently, but in daily use, noise is generated due to some irresistible factors. When these noises appear, we need to be vigilant. This is already an invisible problem in the body. It is necessary to carry out some inspections on the climbing frame electric hoist to identify these problems.
Under normal circumstances, the noise is caused by the following reasons:
When the climbing frame electric hoist makes a beep during the load process, it is generally
The tripod in the gearbox is not installed in place or the size does not match, so there is a dripping noise during operation. At this time, we need to reinstall the tripod or replace it with a new one. During the load process, the tripod appears to be large and small. Sound problem, this is
The tripod or sun gear in the gearbox is not installed in place or the size is not matched, which is caused by uneven belt power. At this time
Reinstalling or replacing the tripod or sun gear will improve these problems
If the electric climbing hoist has a different sound during the lifting process, we need to check
Gear sets in the gearbox are generally due to
Insufficient meshing of the internal gear set of the hoist gearbox
If there is a humming sound on the motor and the body does not operate normally, then we need to stop using it immediately to prevent
To prevent the body motor from overheating and burn-in problems, check whether the voltage of the power supply system is normal after the power is off, and make sure that the voltage is within the range of the body's normal operation.
When the airframe is running, the frame will have a halt, causing the frame to emit noise. At the same time, the airframe will also have a bright stutter, which is generally a regular stutter. ,
Mostly because the chain of the machine body is twisted, the chain jam phenomenon occurs (when the machine body is installed, the hook is turned over, causing the chain to be twisted. During operation, when the chain link of the chain passes through the cruise ship, the chain link cannot match the card slot of the cruise ship, resulting in Lag, this problem mostly occurs in multi-chain hoists)
Stop the operation immediately and correct the chain misalignment of the problematic body. If it is not handled in time, the chain and cruise ship will be damaged, or even the chain will break.
The above is a summary of the noise causes during the operation of the climbing frame hoist. In addition, during operation, you must do a good job of maintenance and monitoring. Don't panic when encountering problems, cut off the power in time, and solve them in time. Do not be careless and safe. Small things, please do the maintenance work of the climbing frame electric hoist.
