Climbing frame electric hoist lifting products are widely used in construction projects, so the safety of the climbing frame electric hoist must be guaranteed. The following is the content that needs to be paid attention to during the operation of the climbing frame electric hoist. I hope all operators should Keep in mind: 1. Construction personnel should abide by the relevant provisions of the current "Technical Specifications for Safety in Construction at Heights (JGJ80)" and "Safety Technical Operation Rules for Construction Workers" ([80] Jiangong Laozi No. 24). Personnel of all types of work should be basically fixed, and hold posts with certificates. 2. The electricity used for construction shall comply with the requirements of the current "Technical Specifications for Safety of Temporary Electricity at the Construction Site" (JGJ46-2005). 3. The outer side of the frame body is surrounded by a dense-mesh safety net and passed over the bottom of the frame body. A small eye net should be added at the bottom, and both the dense-mesh safety net and the small eye net should be reliably fixed on the frame body. 4. The material platform shall be set up and lifted separately, and the force transmission rod shall not be shared with the climbing frame. 5. It is forbidden to lift and lower the electric hoist of climbing frame in strong wind, rain, snow, thick fog and nighttime. Sixth, implement the safety inspection work, especially before and after the lifting of the electric hoist of the climbing frame. Check the record carefully. 7. In the process of pretensioning the steel wire rope before lifting, excessive overload should be avoided.8. During the lifting operation of the climbing frame electric hoist, it is necessary to have unified command, clear division of labor, instructions and specifications, and be equipped with necessary patrolling personnel. 9. When the electric hoist of the climbing frame is used for lifting operation, construction work shall not be carried out on the outer frame, and unrelated persons shall not stay on the scaffold. 10. The pulley, guide wheels and all threads should be regularly lubricated to ensure that the electric hoist of the climbing frame can move freely when used, and it is easy to assemble and disassemble. 11. The search of the lifting console should be operated by a special person, and no idle personnel are allowed to enter. 12. In the process of using the climbing frame electric hoist, the construction load on the scaffold must comply with the design regulations. It is strictly forbidden to overload and place concentrated loads that affect the safety of local rods. Construction waste should be cleaned up in time. 13. The climbing frame can only be used as an operating frame, not as a formwork support for an external formwork. 14. The parts of the electric hoist of climbing frame shall not be reduced, moved or removed at will.15. During the lifting operation, the electric hoist should be prevented from turning and twisting. 16. The position of the wall bolt must be accurate. When climbing the electric hoist, it should be checked at any time whether the guide rail is excessively squeezing the crossbeam or getting out of the constraint of the guide wheel. 17. After lifting, the scaffold must be fixed in time. The operator of the scaffold must not get off work or hand over the get off work before completing the work of fixing the electric hoist of the climbing frame and completing the handover procedures. 18. When disassembling the electric hoist of climbing frame, always check the welding condition of components and whether there are cracks and deformations in the wall bolts.