In the work of the group hoist
electric hoist, the temperature of the group hoist electric hoist motor is often too high. This phenomenon must not be taken lightly, and it should be taken seriously.
1. The mechanical department of the equipment should be checked before lifting the group hoist. The chain, hook, limiter, etc. should be intact. The electrical department should be checked for leakage and the grounding device should be good. Every time you lift a heavy object, you should park your car and check the braking condition when you are 10cm above the ground. You can work only after confirming that it is in good condition.
2. An odor occurs during the hoisting of the group hoist electric hoist. High temperature should be parked and checked immediately to find out the reason and work can be carried out after the treatment.
3. The lifting objects of the group hoist electric hoist should be tied firmly and centered. When walking with heavy loads, the heavy objects should not be too high from the ground. It is strictly forbidden for heavy objects to pass over the head of the person. The heavy objects must not be suspended in the air during the work.
4. The group hoist electric hoist is not allowed to be overloaded. When lifting, the hand is not allowed to be held between the chain and the object. When the lifting object rises, beware of conflicts.
5. During the lifting of the group hoist electric hoist, when the heavy objects slide down due to the failure, emergency measures must be taken to drop the heavy objects to no one.
6.Sixth, the group hoist
electric hoist outdoor work should be set up rain shelter.
7. Group crane electric hoist must lift the heavy objects vertically. Do not pull the heavy objects diagonally, and do not hang the heavy objects.
8. Use the hanging cable electrical switch to start, the insulation must be good, the sliding must be free, and the button should be accurately manipulated and pay attention to the standing position of the person.
Nine, after the work of the group hoist electric hoist is completed, the group hoist electric hoist should stop at the designated position, the hook is raised, and the power supply is blocked.
