The electric hoist of climbing frame is a lifting product applied on the climbing frame. The product is mainly used for the lifting work of the electric climbing frame. At present, there are some common problems in the installation and use of electric climbing frames in China: First, the guide seat: the installation position of the machine seat and the guide seat is too large from the wall surface; there is too much garbage on the guide seat, and the guide seat and the plug under the machine seat are not cleaned in time Wooden side; cracks on the wall surface of the machine position; serious deformation of the machine position has not been treated; the installation position of the guide seat is tilted; the guide seat is not supported by the support object. Second, the guide rail: the guide rail is seriously deformed; the guide rail is deformed seriously or the spacing is too large; the material of the guide rail does not match. 3. Chain: The chain is not oiled. 4. Aisle plate: The aisle plate is seriously deformed; the aisle plate has too much garbage and has not been cleaned; the aisle plate is tilted and untreated. 5. Top brace: The top brace of the climbing frame has not been pushed back into place and is deformed. Sixth, the diagonal rod: the deformation of the diagonal rod is serious; the setting of the diagonal rod does not meet the usage specifications. 7. Up and down lifting points: The device on the lifting point of the climbing frame is skewed and there is serious deformation; the hanging point is seriously deformed. 8. Electric hoist for climbing frame: The shell has no protective cover. 9. Main Frame: The vertical main frame is not connected in place. 10. Dense mesh: The mesh mesh is missing or not fixed in place.